Frigidaire 318200880 Use & Care Manual page 19

1st
Surface
Burner
Grate
2nd
3rd
Electrode
Orifice
holder
Figure 1
Surface Burner
Grate
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
THE INNER VENT IS NOT REMOVABLE. Do not attempt to remove the inner vent cover.
Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition
or prevent the burner from igniting.
Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be
made by authorized servicer.
Care & Cleaning
Cleaning the Burner Grates, Burner Caps, Burner Heads
The Burner Grates, Burner Caps, and Burner Heads should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an uneven flame
at each burner position. Refer to the following instructions:
To Remove and Replace the Surface Burner Grate, Surface Burner Cap and
Surface Burner Head - Remove in the following order; (1st) Surface Burner Grate,
(2nd) Surface Burner Cap, (3rd) Surface Burner Head (See Figure 1).
Surface
Reverse the procedure above to replace the Surface Burner Cap, Surface Burner
Burner
Head and Surface Burner Grate. Do not remove any burner parts from the
Cap
cooktop until the burner parts have completely cooled and are safe to handle.
Do not operate the surface burners without the Surface Burner Caps, Surface
Burner Heads and Surface Burner Grates properly in place.
Sur-
face
To Clean the Burner Caps, Burner Heads and Grates - Use a soap-filled scouring
Burner
Head pad or a mild abrasive cleanser to clean the surface burner caps and surface burner
heads. The Grates and the outer vent covers are designed to be Dishwasher safe
for cleaning. The ports (or slots) around the burner heads must be routinely cleaned.
If residue still remains in these ports, use a small-gauge wire or needle to clean the
slots or holes. For proper flow of gas and ignition of the burner—DO NOT ALLOW
SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER
THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface burner cap
and surface burner head in place whenever a surface burner is in use.
Surface Burner Surface Burner
Caps
19
Outer Vent
Heads Covers