Daewoo DPP-42A2(GDBD) User Manual page 8

How to install Cable Holder
The method of wire arrangement
1 Assemble the cable holder enclosed on the back of TV.
(PICTURE 1)
(ASSEMBLY METHOD: After you push the "A"(prominence
part of cable holder) in the hole, rotate the cable holder
clockwise as an angle of 90°. You can separate in reverse
order of assembly.)
2 Open the cable holder. (PICTURE 2)
( you can open the cable holder then press and push "B" part.)
3 After arranging cables with the cable holder, lock "B" again.
(PICTURE 3)
How to Install Cover Bottom
Cover Bottom is used when you want to use the Wall Mounting Unit instead of the Stand Unit.
If you already use the wall Mounting unit, the Cover Bottom would be installed in the Plasma unit.
1 Stand Unit detachment: Remove the nine screws from the back cover as shown in the picture
below.
2 COVER BOTTOM installing: Bolt up the four screws as shown in the picture below.
Cable Holder
Installing Position
1
2 3
9