Table of Contents
Advertisement
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.
To Remove Oven Door (Side Swing models):
1. Pull the door open.
2. While supporting the door with one hand, remove the 2 screws securing the top hinge to the door.
3. Remove the top hinge, then lift up the door to clear the lower hinge pin and remove the door.
To Replace the Oven Door (Side swing models):
1. Insert the door into the lower hinge.
2. Replace the top hinge and secure it to the door with the 2 screws.
Special Door Care Instructions
Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a
later time.
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
Care & Cleaning
Changing the Oven Light
On some models an interior oven light will turn automatically when the oven door
is opened. The oven light may be turned on when the door is closed by using the
oven light switch located on the control panel. On some models, the lamp is
covered with a glass shield held in place by a wire holder. THE GLASS SHIELD
MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with 40-watt appliance bulb only.
4. For models with glass shield, press holder on one side to release glass
shield, change bulb and be sure to replace the glass shield.
Adjusting Your Oven Temperature
12
Advertisement
Table of Contents
