Before Setting Oven Controls; Setting Oven Controls - Frigidaire 318205121 Use & Care Manual

Some models are equipped with a blower
which runs in baking and self-cleaning mode to keep all
internal components at a cool temperature. The blower
may keep running even if the oven has been turned off,
until the components have cooled down.
Oven Vent Location
The ovens are vented at the center trim. When the oven is on, warm
air is released through the vent. This venting is necessary for proper
air circulation in the oven and good baking results.
Air Circulation in the Oven
If using 1 rack, place in center of oven. If using multiple racks, stagger cookware as shown.
For best air circulation and baking results allow 2-4" (5-10 cm) around the cookware for proper
air circulation and be sure pans and cookware do not touch each other, the oven door, sides
or back of the oven cavity. The hot air must circulate around the pans and cookware in the
oven for even heat to reach around the food.
Refer to the Electronic Oven Control Guide for oven settings.

Before Setting Oven Controls

Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide
out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of
the rack upward and slide the rack back into place.
Oven Door Bracket Adjustment
If the oven door is too loose or too tight to open, it is possible to adjust it. There is
an adjustable bracket located on the front frame under the door on the handle side.
(see figure)
To have an oven door opening loosen, push down the adjustable bracket and to have
it tighten, lift up the bracket.

Setting Oven Controls

Oven Vent Location
5
1 Oven Rack
Multiple Oven Racks
(Some Models)