Installing The Guardrail; Installing The Co Regulator And The Co Cylinder - NewAir AK-200 SERIES Owner's Manual

ASSEMBLY INSTRUCTIONS
Also, See Illustrations E & F on pages 12 & 13, showing the hose connections to CO
regulator and the regulator to the beer tap.

Installing the Guardrail

Follow the steps below to install the guardrail.
1. Place the guardrail on top of the cabinet.
2. Align all support feet of the guardrail with the holes on the top of the unit.
Installing the CO Regulator and
the CO Cylinder
2
Follow these steps to safely install the CO
regulator and CO cylinder. You must read
and understand the following procedures
for the CO cylinders before installation.
2
NOTE: Your CO cylinder has DOT (USA
2
Department of Transportation) approval
however the cylinder has been shipped
empty to avoid any possible accidents
during transportation. When you purchase
the first keg of beer, you must also have
your CO cylinder filled at your local
2
supplier. (See page 4, item 9 for
suggested locations within your community.)
1. Install the CO gas line tube to the regulator by attaching one end of the tube to
the hose barb connection on the CO regulator. (See Illustration B, on page 6)
Insert the special washer (provided with the kit) into the regulator to cylinder
2.
attachment nut. (See Illustration A, on page 6)
3.
Attach the CO regulator to the CO cylinder by screwing the regulator nut onto
the cylinder valve and tightening with an adjustable wrench.
Wrap the rubber strap that is attached to the interior of kegerator unit
4.
around the CO bottle to secure the bottle in place (as shown above).
5. Position the cylinder so that you would be able to read the numbers on the
gauges and have easy access to shut-off valves.
2
2
2
2
2
Shut-Off
Valve
CO
2
Regulator
2
Co
2
Gas Line
;
2
2
7
Connect to
CO Cylinder
2
Co
2
Rubber
Strap
CO
2
Cylinder
2
Rubber
Washer