Battery Installation; Battery Charge - Panasonic KX-TG1702NZ Operating Instructions Manual

Battery installation

Important:
• Wipe the battery ends (+,–) with a dry
cloth.
• Install the batteries without touching the
battery ends (+,–) or the unit contacts.
1 Press the notch of the handset cover firmly
and slide it in the direction of the arrow.
2 Insert the batteries negative (–) terminal
first. Close the handset cover.
Note:
• Use only the included rechargeable
batteries.

Battery charge

Place the handset on the base unit or
charger for about 10 hours before initial use.
When charging,
shown on the display. When the batteries are
highly charged,
Battery strength
Battery icon Meaning
The handset can be used.
Needs to be charged.
and are alternately
remains on the display.
Panasonic Ni-MH battery
performance
When you charge the batteries for 10
hours from the battery empty status, the
following performance is available.
Operation
In continuous use
In continuous
standby mode
* When operation temperature is 25
Note:
• It takes 10 hours to fully charge the
batteries, however, you can use the
handset if
while charging.
• It is normal for batteries not to reach
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
• Actual battery performance depends
on a combination of how often the
handset is in use and how often it is
not in use (standby).
• Even after the handset is fully
charged, the handset can be left on
the base unit or charger without any ill
effect on the batteries.
• The battery strength may not be
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and charge for at least 10 hours.
Preparation
Operation time
10 hours max.*
120 hours max.*
remains on the display
o
C.
7