Handset Registration; Wall Mounting; Specifications - Panasonic KX-TG1702NZ Operating Instructions Manual

Handset registration

The included handset and base unit are
preregistered. If
handset display when the unit is turned
on, the handset is not registered to the
base unit. Register the handset.
1 Base unit:
Press and hold page button [
about 10 seconds to go to registration
mode.
• If all registered handsets start ringing
in step 1, press [
again.
2 Handset:
[ /OK] > [
setting "0000", page 11) > [
• "-Sub-" flashes on the display.
• Handset will search base unit for
registration.
• When the registration is completed,
lights and a beep sounds.

Specifications

• Number of channels: 120 Duplex
Channels
• Frequency range: 1.88 GHz to 1.9 GHz
• Duplex procedure: TDMA (Time
Division Multiple Access)
• Channel spacing: 1,728 kHz
• Bit rate: 1,152 kbit/s
• Modulation: GFSK (Gaussian
Frequency Shift Keying)
• RF transmission power: Approx. 250mW
• Power source: 220–240 V, 50 Hz
• Voice coding: ADPCM 32 kbit/s
• Power consumption:
Base unit:
Standby: Approx. 3.5 W
Maximum: Approx. 9.2 W
Charger *1 :
Standby: Approx. 0.6 W
Maximum: Approx. 5.0 W
is not shown on the
] for
] to stop and try
] > Input PIN (factory
/OK]
• Operating conditions: 5 °C–40 °C,
20%–80 % relative air humidity (dry)
• Dimensions:
Base unit: Approx. 47 mm × 116 mm ×
107 mm
Handset: Approx. 142 mm × 34 mm ×
47 mm
*1
Charger : Approx. 45 mm × 88 mm ×
79 mm
• Mass (weight):
Base unit: Approx. 120 g
Handset: Approx. 120 g
Charger *1*2 : Approx. 300 g
*1 KX-TG1702
*2 Includes the AC adaptor.
Note:
• Specifications are subject to change.
• The illustrations used in these
operating instructions may differ
slightly from the actual product.

Wall mounting

Base unit
Useful Information
70 mm
Screws
19