Philips V30 107T50 Service Manual page 24

24 X
107T5
Go to cover page
Step 5: **Configuration Setup & Enter Factory Mode **
for "write EDID data"
1. Click icon from the tool bar to bring up the Configuration Setup
windows again. Then, select "Software DDC only" as shown in
Fig. 16. Click "OK".
If you do not select "Software DDC only", when you execute
"write EDID", it will bring up an error message as below.
To access factory mode
1. Turn off monitor (don't turn off PC)
2. Press " " and " " simultaneously on the front control
panel,then press " ",wait till the OSD menu with characters
V30 10T5 P V2.01 20030110 (below OSD menu)" come on the
screen of monitor.
Fig. 17
MODEL SELECT
Factory
Mode
Indicator V30 107T5 P V.2.01 20030110
If OSD menu disappears on the screen of monitor, press "
again (anytime), then the OSD menu comes on the screen again.
If you do not access "Factory mode", when you execute
"write EDID", it will bring up an error message as below.
DDC Instructions
Step 6: Write DDC data
1. Click
Bring up "Writing 0%~100%, ready" a progressing bar on the left
down corner.
2. Click
Step 7: Confirm Serial Number in User Mode
1. Press the
again to turn on the monitor.
2. Press the
3. Press the
button to confirm your selection.
4. Confirm the Serial Number "123456" is updated
as shown in Fig. 18.
Fig. 16
Step 8: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click
and give a file name as shown in Fig. 19.
The file type is EDID301 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes, hex
code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into EEPROM for
DDC Data application.
2. Click Save
"
(Write EDID) icon from the tool bar to write DDC data.
(Read EDID) to confirm it.
button to turn off the monitor. Press the
button to bring up the OSD Main Menu.
button to select Extra Controls, press the
Fig. 18
(Save) icon (or click "file"-> "save as") from the tool bar
107T5 V30
.
button
Fig. 19