Table of Contents
Advertisement
46
107T5
Go to cover page
1.0
Introduction
This document is related to the 17" AUTOSCAN (VGA above and Max. resolution
1280X1024 by 60HZ refresh) color monitor for world-wide destination.
2.0
General description
The AUTOSCAN analog color monitor is specified as a display peripheral within
The AUTOSCAN analog color monitor is to operate at horizontal line rates
RGB analog computers within this scanning frequencies.
The AUTOSCAN analog color monitor is intended to be a finished product,
basically a display device mounted inside a plastic enclosure which provides the aesthetic
mechanical, ergonomic and safety requirements.
2.1
General condition
The unit will produce a usable image after switching-on, measurements are to be carried out
with a full stabilized set after 30 minutes warm-up at room temperature of 25° C.
Repetitive power on/off cycles are allowed though should be avoided within 4 sec.
3.0
Electrical characteristics
3.1
Signal interface
The AUTOSCAN analog color display has an analog video interface to operates at a
multi-frequencies timing in several display modes.
3.1.1 Input requirements
A. Input signals
Video
Sync.
Polarity : Positive or negative
B. Signal input level
Video : 0.7 Vp-p 75 ohms (for individual of R,G and B signals must not
Sync : TTL level
C. Impedance
Video : Terminated with 75 ohms
Sync : Terminated with 4.7K ohms pull down resistors.
2003-01-07
Wayne Lin
GENERAL PRODUCT SPECIFICATION
an IBM PC, PS/2 ,VGA and advance VGA compatible system.
between 30 to 71 KHz and refreshment rate between 50 to 160 Hz, can be applied to all
: Analog level
: Separate sync. with TTL level
deviate 0.015 Vp-p from each other for balance of white pattern)
(between 0 and 0.6 V to be considered as low level, between 2.3 and 5.0 V as
high level)
17" V30 GS4 107T5-71K CMTR
TYPE
: 107T51/00
BRAND
: PHILIPS
2003-01-07
30
590
4
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
