Label Gone Timeout; Pdf Label Gone Timeout - PSC Magellan 1400i Product Reference Manual

General Features

Label Gone Timeout

This feature sets the time after the last label segment is seen before the scanner prepares for a
new label.
START / END
Sets the label gone timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To
configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode, then the "Set Label Gone Tim-
eout," followed by three digits (zero padded) from the Alphanumeric table in
desired time value. Exit programming mode by scanning the "START/END" bar code again.

PDF Label Gone Timeout

This setting specifies how long the
PDF label segments prior to discarding data.
START / END
Sets the label gone timeout duration using hex values from 001 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To
configure this feature, scan the "START/END" bar code above to place the unit in Programming Mode, then the "Set PDF Label Gone
Timeout," followed by three digits (zero padded) from the Alphanumeric table in
desired time value. Exit programming mode by scanning the "START/END" bar code again.
2-4
PROGRAMMING BAR CODES
DEFAULT SETTING FOR THIS FEATURE: 200 milliseconds (020)
PROGRAMMING BAR CODES
DEFAULT SETTING FOR THIS FEATURE: 1.5 Seconds (150)
Appendix C, Alpha-Numeric Pad
Set Label Gone Timeout
timer runs when specifically collecting
Label Gone Timeout
Appendix C, Alpha-Numeric Pad
Set PDF Label Gone Timeout
representing the
representing the
®
Magellan 1400i