Radio Shack PRO-2067 Owner's Manual page 38

bank (see "Storing a Frequency to
a Specified
Page 26).
5. Repeatedly press
the trunking mode (
Johnson, MO
for the EDACS (GE/Ericsson) sys-
tem).
6. Press
SCAN
receive mode matches the ID
mode, appears and the scanner
T
scans the frequencies.
Programming Motorola
Trunking Systems (UHF-Lo)
You can program the scanner to re-
ceive transmissions in the UHF-Lo
band (380–512 MHz) of the Motorola
Trunking System. You can receive
these transmissions by:
• Checking the trunking system's
base frequency and offset fre-
quency. You must program the
system's base frequency and off-
set frequency to do this.
• Decoding the subaudible data
transmitted with the signals. When
you do this, the scanner might
detect wrong IDs but you can eas-
ily receive trunking frequencies
without programming the base
and offset frequencies.
Notes:
• Base and offset frequencies vary
for each type of trunking system.
You can get information about
these frequencies for the trunking
system you want to scan using
38
Channel"
to select
MODE
LT for EF
for Motorola, or
. If the scanner's
www.trunkscanner.com ,
on Internet sources, or locally-
published guidebooks.
• The scanner automatically de-
codes subaudible data it receives
ED in the VHF band.
• If you try to enter an offset fre-
quency in the VHF and UHF-Hi
bands (137–174 and 806–960
MHz), the scanner will ignore the
entry.
Follow these steps to program Motor-
ola trunking frequencies in the UHF-
Lo band.
1. Select the bank, then press
to enter the program mode.
2. Store the base frequency into
channel 00 of the bank you
selected, then store the trunking
frequencies
channels in the same bank (see
"Storing a Frequency to a Speci-
fied Channel" on Page 26).
3. Press
press
ola).
4. Press
(the
appears.
into subsequent
then repeatedly
TRUNK
to select
MODE
then .
12.5 kHz
FUNC 9
default offset
Offset Frequency
other
PROG
MO (Motor-
frequency)