Table of Contents
Advertisement
5 TOOLS RECOMMENDED FOR
INSTALLATION
•
Phillips Screwdriver
•
Electric Drill
•
",
" and
" Drill Bits
•
1
" Wood Bit or Metal Hole Cutter
(if metal cabinet is used)
•
Saw to cut exhaust opening (if needed)
•
Protective Drop Cloth for product and range -
you may also use carton for protection
•
Scissors
•
Pencil
•
Measure
•
Tape
6 INSTALLATION HARDWARE
The INSTALLATION HARDWARE (items 1 - 7 ) packed with
the oven should contain the following:
Item
Wood Screw 5 x 35 mm
1
Toggle Bolt
2
Top Cabinet Screw 5 x 85 mm
3
Flat Washer 30 mm diameter
4
Grommet
5
Tapping Screw 4 x 8 mm
6
Exhaust Damper Assembly
7
Grease Filter
8
Parts shown not to common scale.
INSTALLATION INSTRUCTIONS
Name
Quantity
"
Figure 4
7 PREPARATION OF THE OVEN
1. Open the bottom of the carton, bend the carton flaps back
and tilt the oven over to rest on plastic foam pad. Lift carton
off oven and remove all packing materials, Installation
Instructions, Wall Template, Top Template, Charcoal
Filter, Turntable and Turntable Support; however, DO
NOT REMOVE THE WAVEGUIDE COVER, which is
located on the ceiling in the oven cavity. SAVE THE
CARTON AS IT MAY MAKE INSTALLATION EASIER.
2. CHECK THE OVEN.
Check the oven for any damage, such as misaligned or
bent door, damaged door seals and sealing surfaces,
broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not
operate the oven and contact your dealer or Electrolux
AUTHORIZED SERVICER.
6
4
2
2
1
4
1
2
E3
Mounting Plate
Figure 5
Advertisement
Table of Contents
