Frigidaire 316137234 Installation Instructions Manual
Frigidaire 316137234 Installation Instructions Manual

Frigidaire 316137234 Installation Instructions Manual

Frigidaire over the range microwave oven installation instructions

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS

Over The Range Microwave Oven

BEFORE YOU BEGIN

IMPORTANT
Save these instructions for local
inspector's use.
IMPORTANT
Observe all governing codes and
coordinates.
NOTE TO INSTALLER
instructions with the Consumer.
NOTE TO CONSUMER
future reference.
SKILL LEVEL
– Installation of this appliance requires
basic mechanical and electrical skills.

1 MOUNTING SPACE

This Microwave Oven/Hood requires a mounting space on
a wall as shown in Figure 1. It is designed to be used with
standard 12" wall cabinets.
12"
15.5"
At least 2"
Backsplash
P/N 316137234
Read these instructions completely and carefully.
– Be sure to leave these
– Keep these instructions for
30"
30" or more
from cooking
surface
66" or more
from floor
Figure 1
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
If a new electrical outlet is required, its installation should be
completed by a qualifi ed electrician before the Microwave
Oven is installed. See 3 ELECTRICAL GROUNDING
INSTRUCTIONS on page 2.

2 WALL CONSTRUCTION

This Microwave Oven/Hood should be mounted against and
supported by a fl at vertical wall. The wall must be fl at for
proper installation. If the wall is not fl at, use spacers to fi ll in
the gaps. Wall construction should be a minimum of 2" x 4"
wood studding and " or more thick dry wall or plaster/lath.
The mounting surfaces must be capable of supporting weight
of 110 pounds—the oven and contents—AND the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one 2" x 4"
wall stud or two 2" x 3" wall studs.
To fi nd the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to fi nd the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
NEED HELP?
For customers in the United States, call: 1-800-944-9044
For customers in Canada, call: 1-800-213-9397 (English)
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
1-800-668-4606 ext.8199 (French)
TINSEB151WRRZ
Printed in Thailand

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire 316137234

  • Page 1: Installation Instructions

    Product failure due to improper installation is not covered under the Warranty. • Please read all instructions thoroughly before installing the Over the Range Microwave Oven. Two people are recommended to install this product. • If a new electrical outlet is required, its installation should be completed by a qualifi...
  • Page 2: Electrical Grounding Instructions

    3 ELECTRICAL GROUNDING INSTRUCTIONS This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances.
  • Page 3: Installation Hardware

    5 TOOLS RECOMMENDED FOR INSTALLATION • Phillips Screwdriver • Electric Drill • ", " and " Drill Bits • " Wood Bit or Metal Hole Cutter (if metal cabinet is used) • Saw to cut exhaust opening (if needed) • Protective Drop Cloth for product and range - you may also use carton for protection •...
  • Page 4: Ventilation System

    8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION) This microwave oven/hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. RECIRCULATING — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has already been installed in the oven.
  • Page 5: Oven Installation

    Tapping Screw Figure 10 8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION) (C) VERTICAL EXHAUST: OUTSIDE VENTILATION 1. Remove and save 2 screws from back edge and 1 screw from the top center of the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 7.
  • Page 6 Wall Figure 13 MOUNTING OVEN TO THE WALL Two people are recommended to attach the Microwave Oven/ Hood to the Mounting Plate. 1. Thread the power supply cord through the hole made in the bottom of the top cabinet.
  • Page 7: Checklist For Installation

    INSTALLATION INSTRUCTIONS CHECKLIST FOR INSTALLATION 1. Make sure the unit has been installed according to all of the Installation Instructions and the Wall and Top Cabinet Templates. 2. Plug in the power cord. 3. Keep the Operation Manual.
  • Page 8 NOTES...

This manual is also suitable for:

Tinseb151wrrz

Table of Contents

Save PDF