Checks With Engine Running; Dinamic Test With Vehicle Running; Checks After Dynamic Test - Subaru IMPREZA 2004 Service Manual

PROCEDURE
17. AT front differential oil
18. Engine coolant
19. Clutch fluid
20. Window washer fluid
21. Front hood latch check
22. Keyless entry system
23. Seat
24. Seat belt
25. Wheel alignment

CHECKS WITH ENGINE RUNNING

PROCEDURE
26. Test mode connector
27. Immobilizer system
28. Starting condition
29. Exhaust system
30. Indicator and warning lights
31. Clock
32. Audio
33. Front accessory power supply socket
34. Lighting system
35. Window washer
36. Wiper
37. Power window operation check
38. Sunroof
39. Door mirror
DYNAMIC TEST WITH VEHICLE RUNNING
PROCEDURE
40. Brake test
41. Parking brake
42. AT shift control
43. Heater & ventilation
44. Air conditioner
45. Cruise control

CHECKS AFTER DYNAMIC TEST

PROCEDURE
46. ATF level
47. Power steering fluid level
48. Fluid leak check
49. Water leak test
50. Appearance check 2
Pre-delivery Inspection
Check that the AT front differential oil level is normal.
Check that the engine coolant level is normal.
Check that the clutch fluid level is normal.
Check that the window washer fluid level is normal.
Check that the hood is closed and latched securely.
Check that the keyless entry system operates normally.
(1) Check the seat surfaces for stain or dirt.
(2) Check the seat installation conditions and functionality.
Check the seat belt installation conditions and functionality.
Check that the wheel alignments are properly adjusted.
Test mode connectors
(1) Check that the engine starts with all keys that are equipped on vehicle.
(2) 60 seconds after turning ignition switch from ON to ACC or OFF, or imme-
diately after removing key, check that the security indicator light blinking.
Start the engine and check that the engine starts smoothly.
Check that the exhaust noise is normal and no leaks are found.
Check that all the indicator and warning lights are gone out.
Check that the clock operates normally.
Check the radio, CD and MD player for normal operation.
Check that the front accessory power socket operates normally.
Check that the lighting system operates normally.
Check that the window washer system operates normally.
Check that the wiper system operates normally.
Check the power window for normal operations.
Check that the sunroof operates normally.
Check that the remote control mirror operates normally.
Check the foot brake for normal operations.
Check the parking brake for normal operations.
Check that the AT shift patterns are correct.
Check that the heater & ventilation system operates normally.
Check that the air conditioner operates normally.
Check that the cruise control system operates normally.
Check that the ATF level is correct.
Check that the power steering fluid level is normal.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
(1) Remove the protective coating (if any).
(2) Check the body paints for damage and stain.
(3) Check the plated parts for damage and rust.
PI-3
PRE-DELIVERY INSPECTION
Check point
Check point
Check point
Check point