Lap Data Mode - Timex Bodylink System User Manual

Lap Data Mode

Lap Data Mode allows you to review stored lap information for
time and heart rate information. To record lap data, you must run
the chronograph.
INDIGLO®
night-light
To Summary
Mode or hold
for time
When you use Lap Data Mode, each recalled lap will display three
lines of data. The lower line will show the lap number labeled RCL
(for recall) for each lap you stored in the chronograph.
Access this information using these steps.
1. Press MODE until the Lap Data Mode appears.
2. Press L (DISPLAY) or M
data for each lap.
Viewing data in Lap Data Mode
As you press the buttons, you will review information for each lap.
This information includes:
Lap time includes data for each segment of
Lap and split time:
®
your activity, and split time shows data for the overall activity.
30
L
data value
M
data value
(STOP/RESET) to navigate through
Lap average heart rate and time in average heart rate:
®
Average heart rate displays the average heart rate for the lap,
and time in average heart rate shows how much time during the
lap you spent at the average heart rate.
Lap Data Mode tips & tricks
Once you restart the chronograph from zero for your next
®
activity, you erase lap data from your previous activity.
If you want to view information for your entire activity refer to
®
Summary Mode in the next section.
If you have activated
SYNC TIMER & CHRONO
®
then your lap data is equivalent to your performance for each
interval.
Lap Data Mode example
You love to ride your bike, but you just finished a long ride and
you are exhausted! In your exhaustion, you forget to look at the
lap data for your ride and you reset the chronograph to zero. You
think you have lost your data, but then you remember. You can
still view lap data for your ride, as long as you do not restart the
chronograph first.
(see page 44)
31