The Back Panel; System Requirements - TP-Link TD-W8920G User Manual

WLAN
Slow flash
Quick flash Sending or receiving data over wireless network
(1-4) LAN

3.3 The Back Panel

The Router's ports, where the cables are connected, and RESET button are located on the back
panel.
Line: Connect to the Modem Port of Splitter or to the telephone line.
Reset Button: There are two ways to reset the Router's factory defaults. Press the reset
button of the Router, and then power on the Router, hold reset button pressed down for about
five seconds, or restore the default setting from "Management - Settings - Restore Default "of
the Router's Web-based Utility.
1, 2, 3, 4 (LAN): Through these ports, you can connect the Router to your PCs and the other
Ethernet network devices.
Power: The Power plug is where you will connect the power adapter.
Antenna: Used for wireless operation and data transmit.

3.4 System Requirements

Make sure your computer has a Networking Interface Card (either wired or wireless is ok)
TD-W8920G
Off The Wireless function is disabled
The Wireless function is enabled
Off There is no device linked to the corresponding port
On Connected to a device through the corresponding port
Flashing Sending or receiving data over corresponding port
Figure 3-2
108M Wireless ADSL2+ Router User Guide
11