Advertisement
1. Install Feed to Dish
Install
Feed to
Dish by:
B
A
M4 Bolt-Springlock-Washer Assembly (Qty. 6)
T
The Dish/Feed are keyed so that the feed can only be installed one way.
To install, line up the alignment pin on the Dish with the hole on the Feed
as shown in gure 1.
2. Install Main Mounting Bracket and Elevation Rod
Put
M12X180 Bolt on the
I
C
Main Mounting Bracket and
G
M10X25 Carriage Bolt (Qty. 3)
J
M10 Washer (Qty. 3)
R
M10 Spring Lock Washer (Qty. 3)
S
M10 Nut (Qty. 3)
Q
Pivot Points should be loose to allow mounting frame to move so that
elevation rod can be installed.
3. Install Rocket and Waterproof Cables
Model MD-5G34 and MD-3G30 go to step 4.
Install Rocket by lining up slots on Rocket/Dish bracket. Slide into place.
Install
Waterproof Cables (Qty. 2) to Rocket/Dish connectors.
F
Rubber boot to be placed over connectors for weatherproo ng.
4. Attach Stabilizer Bracket to Pole
Select location for Dish antenna and attach the stabilizer bracket to
mounting pole just below where Dish will be installed as shown in gure 4.
Tighten to 14M-m (10 lb-ft). Install
M10X100 Bolt (Qty. 2)
H
M10 Washer (Qty. 2)
O
M10 Spring Lock Washer (Qty. 2)
P
M10 Nut (Qty. 2)
N
5. Attach Antenna to Mounting Pole
Mounting bracket can accommodate
Mount the antenna slightly above the stabilizer bracket as shown in gure 5
using the following parts:
M12X180 Carriage Bolt (Qty. 4)
I
M12 Washer (Qty. 4)
O
M12 Spring Lock Washer (Qty. 4)
P
M12 Nut (Qty. 4)
N
6. Adjust Azimuth and Elevation
After a visual alignment of both elevation and azimuth, azimuth can be
adjusted by rotating the antenna while supported by the stabilizer bracket.
Elevation is adjusted by tightening/loosening the elevation rod.
When azimuth/elevation are set tighten nuts to approximately
14N-m(10 lb-ft) or less should the mounting pole show deformation.
Main Mounting Bracket. Install
Elevation Rod to
Dish by:
A
M16 Washer (Qty. 2)
L
M16 Spring Lock Washer (Qty. 1)
M
M16 Nut (Qty. 2)
K
Stabilizer Bracket to pole by:
E
1.5"-4"pole.
1
C
2
3
4
5
6
Advertisement
