Yamaha mLAN16E Software Manual page 13

24
The "Make the driver initial settings" dialog
box is displayed. Click [OK].
25
• During Steps and
the computer displays a window indicating that
you are now making the initial settings for each
driver. This window also indicates the number of
times the "Found New Hardware Wizard" will be
displayed during the procedure. Unless you wish
to cancel installation, do not close this window.
Example:
mLAN Network initial settings
25
The computer automatically displays the
"Found New Hardware Wizard." Check the
radio button next to "Install the software
automatically [Recommended]," then click
[Next].
26
When the installation is complete, the com-
puter displays a message indicating that
installation is complete. Click [Finish].
27
25
Repeat Steps
(indicating that you are making the mLAN
Bus driver initial settings) closes.
26 28 29
, and Steps and
26
and until the window
mLAN MIDI Port initial settings
28
The computer automatically displays the
"Found New Hardware Wizard." Check the
,
radio button next to "Install the software
automatically [Recommended]," then click
[Next].
29
When the installation is complete, the com-
puter displays a message of indicating that
installation is complete. Click [Finish].
30
Repeat Steps
(indicating that you are making the mLAN
Stream driver initial settings) closes.
31
The computer displays a message indicat-
ing that the initial settings for mLAN driver
are complete. Click [OK].
To use an audio sequencer via mLAN, you
must connect the computer to the mLAN
device using mLAN audio Connector or
Graphic Patchbay (page 19).
TOOLS for i88X/mLAN16E, Plug-in Effect
28 29
and until the window
Installation Guide
13