Checking Operation; Model And Serial Number Location; Before You Call For Service - Frigidaire 318205403 Installation Instructions Manual

ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
3. Models: 32" Coil Elements Cooktops
1. Place cooktop into countertop opening and center
unit in cutout.
2. Remove all surface units and drip bowls.
3. Unit clamp down information. Once unit is installed in
counter opening, you must clamp unit down as shown
in figure 12.
4. Put back all surface units and drip bowls.
5. Make electrical connections as outlined in "Electrical
Connection" section.
Reach down through surface unit openings and install
the four hold down retainers with screws as shown. Be
certain cooking top is firmly retained to counter top.
Cooktop
Hold down retainer
Burner box
Figure 12
4. Models: 30" and 36" (36" X 21½") Coil Elements
Cooktops
- These cooktops are designed to fit various cutout sizes.
The minimum and maximum cutout openings are
shown in figure 1.
- If cooktop is to be used in new installation, use
minimum cutout dimensions in figure 1.
- Attach cooktop to cabinet using wood screws through
holes in vertical walls of burner box.
- If cooktop is to be installed as a replacement in
an existing countertop opening (not exceeding
maximum cutout dimensions as shown in figure
1), the following steps must be taken:
1. Insert 4 screws and installation spacers through holes
in vertical walls of burner box (see figure 13).
2. Place cooktop into countertop opening and center
unit in cutout.
3. Tighten each screw finger tight or until spacers are
snug against burner box walls.
Spacer
Figure 13
4. Prior to tightening installation screws, exert downward
5. Unit clamp down information. Once unit is installed in
6. Make electrical connections as outlined in "Electrical
Nylon spacer
Countertop

Checking Operation

Refer to the Owner's Guide for operation.
They may be hot enough to burn.

Model and Serial Number Location

The serial plate is located under the cooktop or in the
burner box and can be seen by lifting up the main top of
unit.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.

Before You Call for Service

Read the Avoid Service Checklist and operating
instructions in your Owner's Guide. It may save you time
and expense. The list includes common occurrences that
are not the result of defective workmanship or materials
Burner box
in this appliance.
Refer to the warranty in your Owner's Guide for our
Screw
service phone number and address. Please call or write
if you have inquiries about your product and/or need to
order parts.
7
pressure on burner box to assure flanges on burner
box rest firmly on counter. Tighten all screws evenly.
counter opening, you must clamp unit down as shown
in figure 14.
Connection" Section.
To clamp down, insert bracket with offset side of
angle into slot on each side of unit. The screw should
then be run through bracket and against bottom of
counter. Tighten until draws down.
Cooktop
Hold down retainer
Burner box
Figure 14
CAUTION
Do not touch cooktop glass or elements.
Countertop
Screw