Electrical Requirements; Check Operation - Frigidaire FGGC3665KBC Installation Instructions Manual

30" and 36" models
Table of Contents

Advertisement

Available languages

Available languages

6. Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
Do not use an extension
cord with this cooktop.
7. Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Grounding
Instructions
1.
Remove foam caps.
IMPORTANT Please read carefully.
For personal
safety, this appliance
must be properly
grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 9) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by
a qualified electrician to make sure the receptacle is
properly grounded.
Preferred
Method
.
.
Turn on Electrical
Power and Open Main Shutoff
Gas Valve
Check the Igniters
Operation of electric igniters should be checked
after cooktop and supply line connectors have been
carefully checked for leaks and the cooktop has been
connected to electric power.
To operate
the surface burner:
A.
Push in and turn a surface burner knob to the
LITE position. You will hear a small ticking noise;
this is the sound of the electric ignitor which
lights the burner.
B.
After the burner lights, turn to the desired flame
size. The controls do not have to be set at a
particular mark. Use the marks as a guide and
adjust the flame as needed.
Grounding type
wall receptacle
not, under any
circumstances,
cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
Figure 9
Where a standard 2-prong wall receptacle is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Do not, under any circumstances,
cut or remove the
third (ground)
prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.

Advertisement

Table of Contents
loading

Table of Contents