Vauxhall Antara Owner's Manual page 183

182 Vehicle care
5. Attach wheel wrench to eye of
threaded rod and rotate wrench
clockwise to raise vehicle.
If this is not the case, carefully
lower the vehicle immediately and
reposition the jack. Raise the
vehicle until the wheel is just clear
of the ground.
6. Unscrew wheel nuts completely
and wipe clean with a cloth.
Do not grease the threads. Put
wheel nuts somewhere where the
threads will not be soiled.
7. Change the wheel. Notes on
spare wheel 3 183.
8. Screw on the wheel nuts and
tighten slightly by hand by turning
clockwise until wheel is held
against the hub.
9. Rotate wrench anticlockwise and
lower vehicle to the ground.
10. Install the wheel wrench ensuring
that it locates securely and tighten
each wheel nut in a crosswise
sequence. Tightening torque is
140 Nm.
11. Stow the replaced wheel 3 183
and the vehicle tools 3 171.
12. Check the tyre pressure of the
installed tyre as soon as possible.
Have the defective tyre renewed and
replace temporary spare wheel with a
full specification wheel without delay.
Jacking position for lifting
platform
Rear arm position of the lifting
platform centrically under the recess
of the sill.