Vaillant geoTHERM SERIES Installation And Servicing page 44

INSTALLATION
Code function Description
123
124
125
Choose the type of exterior-temperature sensor:
Configurations
126 1 = Remote sensor (connected onto terminal block 23 and 24)
exterior sensor
2 = Sensor installed on the heat pump.
This parameter displays the external temperature measured by the sensor
127 Exterior temperature
installed in the heat pump.
Temperature of
128 the cooling circuit This parameter displays the temperature of the heat pump's cooling circuit battery.
battery
Compressor suction
129 This parameter displays the compressor's suction temperature.
temperature
Compressor
130 discharge This parameter displays the compressor's discharge temperature.
temperature
This parameter displays the functioning state of the heat pump:
1 = Stopped
Functioning state of
131 3 = Heating mode
the heat pump
4 = Fault
5 = Defrost mode
Maximum frequency This parameter displays the maximum frequency of the compressor allowed by the
132
of compressor heat pump's command board.
Required compressor This parameter displays the compressor frequency required by the heat pump's
133
frequency command board.
Real compressor
134 This parameter displays the real frequency of the compressor variator.
frequency
Counter that times
This parameter displays the number of hours during which the compressor has
135 the functioning of the
functioned since first activation.
compressor
Capacity of the heat
136 This parameter displays the capacity of the heat pump.
pump
Return temperature
137 of the heat pump This parameter displays the return temperature of the heat pump's circuit.
circuit
Flow temperature
138 of the heat pump's This parameter displays the flow temperature of the heat pump's circuit.
circuit
Temperature of
the cooling fluid in This parameter displays the temperature of the cooling fluid in the plate to plate
139
the plate to plate exchanger
exchanger
This parameter displays the state of functioning of the system:
0 = Stopped
1 = Standby mode
3 = Heating mode
4 = Booster heating functioning
State of functioning
140 4 = Nominal heating
of the system
8 = Frost protection mode
9 = Defrost
10 = Protection against overheating
11 = Guard interval
12 = System fault
141 Fault codes This parameter displays the fault codes for the heat pump.
Version of the heat
142 This parameter displays the version of the heat pump's software.
pump's software
Update to the heat
143 This parameter displays the latest update made to the heat pump's software.
pump's software
Counter that times
This parameter displays the number of hours during which the circulator has
144 the functioning of the
functioned since first activation.
circulator
Temperature setting
This parameter displays the temperature setting for the installation's water
145 calculated for the
calculated by the command board according to climatic graphs.
installation's water
- 42 -
Not used
Not used
Not used
Installer_manual_OEM_Vaillant_PROTO_3_GB - 06/11 - Vaillant
Setting
factory Modifiable
setting parameter
Min Max
1 2 2 Yes
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No
- - - No