Auto Search Method - Universal Remote Control TOTAL CONTROL FX-1 Owner's Manual

Auto-Search Method
The Auto-Search Method is a way you can scan through
all of the codes in the table to find the right code for your
component.
Using your old remote, turn on the component you want to
program with the FX1... let's say your TV.
Press down on both the Component button (in this case the but-
ton that says TV) and the SELECT (SEL) button at the same time
for 3 seconds until the TV component button LED light turns on.
IMPORTANT: If you do not press a button within 20
seconds the LED light will turn off. The remote will exit
the programming mode and you will have to start over.
Press the UP arrow button once. Each time the UP arrow is
pressed, the code will count up one code number and send a
Power OFF signal. When the correct code is sent out, the com-
ponent will turn off.
7