Configuring The Switch; Login - D-Link DGS-1224T Manual

Configuring the Switch

The DGS-1224T Web Smart Switch has a Web GUI interface for
s mart switch configuration. The Switch can be configured through the
Web Brows er. A network administrator can manage, control and
monitor the switch from the local LAN. This section indicates how to
configure the Switch to enable its smart functions including:
u
Port Setting (Speed/Disable, Duplex mode, Flow Control and
Port base QoS)
u
Virtual LAN Group setting (VLAN)
u
Port-based Trunking
u
Port-based Mirroring
u
System Setting
u
Device status and Statistic

Login

Before you configure this device, note that when the Web Smart
Switch is configured through an Ethernet connection, make sure the
manager PC must be set on same the IP network . For example, when
the default network address of the default IP address of the Web Smart
Switch is 192.168.0.1 , then the manager PC should be set at
192.168.0.x (where x is a number between 2 and 254), and the d efault
subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address http://192.168.0.1 (the factory -default IP address
setting) to the address location.
Figure 13.
22