Configuring The Switch - D-Link DGS-1248T Quick Installation Manual

Configuring the Switch

The DGS-1248T has a Web GUI interface for smart switch configuration.
The Switch can be configured through the Web Browser. A network
administrator can manage, control and monitor the switch from the local
LAN. This section indicates how to configure the Switch to enable its
smart functions.
Note: Use Internet Explorer 5.5 or above Web browser to properly
access and view the configuration.
Login
Before you configure this device, note that when the Web Smart Switch
is configured through an Ethernet connection, make sure the manager
PC must be set on the same IP network. For example, when the default
network address of the default IP address of the Web Smart Switch is
192.168.0.1, then the manager PC should be set at 192.168.0.x (where x
is a number between 2 and 254), and the default subnet mask is
255.255.255.0.
Enter IP address http://192.168.0.1 (the factory-default IP address
setting) to the address location. (Figure 2.)
Or through the SmartConsole Utility, you do not need to remember the IP
Address, select the device shown in the Monitor List of the
SmartConsole Utility to settle the device on the Web Browser.
When the following dialog page appears, remain enter the default
password "admin" and press Login to enter the main configuration
window. (Figure 3.)
After entering the password, the main page comes up, the screen will
display the device status.
Figure 2.
Figure 3.
(Figure 4.)
8