Table of Contents
Advertisement
The Web Management Utility is divided into four parts, Discovery List, Monitor List,
Device Setting, and Toolbar function, for detailed instructions, please refer to User's
Manual.
Configuring the Switch
The DES-1526 has a Web GUI interface for smart switch configuration. The Switch can
be configured through the Web browser. A network administrator can manage, control,
and monitor the Switch from the local LAN. This section indicates how to configure the
Switch to enable its smart functions.
Use Internet Explorer 5.0 or above Web browser.
Login
Before you configure this device, note that when the Web Smart Switch is configured
through an Ethernet connection, make sure the manager PC must be set on same the IP
network. For example, when the default IP address of the Web Smart Switch is 192.168.0.1,
then the manager PC should be set at 192.168.0.x (where x is a number between 2 and
254), and the default subnet mask is 255.255.255.0.
Open the Web browser program and Enter IP address http://192.168.0.1
(the factory-default IP address setting) to the address location.(Figure 2.)
Or through the Web Management Utility, you do not need to remember the IP Address,
select the device shown in the Monitor List of the Web Management Utility to settle the
device on the Web browser.
When the following dialog page appears, enter the default password "admin" and press
Login to enter the main configuration window.(Figure 3.)
Figure 2.
Figure 3.
7
Advertisement
Table of Contents
