Electrical Specifications - U-Line 2175BEVS Installation Manual

Slotted
Mounting
Holes
Raise
Outside
Door Edge
Figure 25
3. See Figure 25. If the top far edge of the door needs to
move UP, move the hinge plate toward the outside of
the door and retighten screws. If the top far edge of the
door needs to move DOWN, move the hinge plate
toward the inside of the door and retighten screws.
4. Mount the door to recheck alignment and repeat
Steps 2 and 3 if further adjustment is necessary.
5. When top edge of door is parallel to top edge of
cabinet, remove the door and ensure the two screws
are secure.
6. Remove the door closers from the bottom hinge, clean
thoroughly and lubricate the mating surfaces with
petroleum jelly.
7. Reinstall the closers, lining
up the bosses with holes in
hinge and hinge plate (see
Figure 26).
8. Mount the door, install top
hinge pivot pin and go on
to 6 Prepare Power
Supply.
01/2007
2175BEV/2175BEVOL Beverage Center
Angled Edge
Towards Center
of Door
Lower
Outside
Door Edge
Door
Closer
Inserts
Boss
Figure 26
6 Prepare Power Supply

Electrical Specifications

Electrical installation must observe all state and local
codes. This unit requires connection to a grounded (three-
prong), polarized receptacle that has been placed by a
qualified electrician.
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A power supply (normal household current).
An individual, properly grounded branch circuit or circuit
breaker is recommended. GFCI (ground fault circuit
interrupter) is usually not required for fixed location
appliances and is not recommended for your unit because
a GFCI could be prone to nuisance tripping. However, be
sure to consult your local codes.
See Figure 27 for recommended receptacle location.
Figure 27
SHOCK HAZARD — Electrical Grounding Required.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
Go on to 7 Level the Unit.
13
CAUTION
23-1/4"
7"
1-1/2"
WARNING
www.U-LineService.com