U-Line 2175BEVS Installation Manual page 10

3. Create a relief for pivot plate by cutting notch in top
corner and coinciding back corner of overlay frame.
Refer to Figure 15 for exact specifications.
13/32"
0.177" Dia. (#16 Drill)
x 11/16" Deep
3/8"
13/16"
Top View
1/8"
13/32"
13/16"
1-17/32"
7/16"
13/16"
5/16" Dia.
x 1/2" Deep
Back View
Figure 15
Route notch in top corner of overlay frame as shown (see
Top and Side Views). Top of notch is entire depth of
frame, front to back.
Width: 13/16"
Depth: 1/8"
Route notch in backside of top corner of overlay frame
(see Back and Side Views).
Width: 13/16"
Depth: 1/8"
Height: 1-17/32" from top edge of frame (less 1/8" for
depth of notch on top of frame)
Radius of corner notch: 1/8" (see Back View)
4. Drill holes for pivot plate mounts (see Figure 15, Back
View).
5/16" diameter x 1/2" deep, from the routed surface
CAUTION
Be careful not to drill too deep! Drilling holes too deep
may destroy your door frame.
www.U-LineService.com
2175BEVS/2175BEVOL Beverage Center
13/32"
3/8"
Door Bottom:
5/16" Dia. x 1/4" Deep
Chamfer 1/32" x 45°
Bottom View
1/8"
1/8"
1/32" R
1/8" R
3/4"
Side View
5. Drill hole for upper door hinge (top of frame) (see
Figure 15, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
6. Drill hole for lower door hinge (see Figure 15, Bottom
View).
5/16" diameter x 1/4" deep
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
Installation Instructions
Preparing Door
Note: Door is not attached. It
is in a separate box inside the
unit box and taped to the
unit.
1. Lay door on a clean, flat
surface with the gasket
facing up.
2. Pull gasket completely out
of the groove. Start in the
middle and pull outward,
moving toward the edge
(see Figure 16). This may take some force.
Note: Lay gasket flat on a clean surface to avoid
disturbing interior magnet.
Checking Overlay Fit
Not Fully Seated
Figure 17
1. Turn door over and lay overlay frame on front side of
door. Make sure frame is fully seated on all four sides.
See Figure 17.
2. Visually check for gap between frame and glass. If there
is an objectionable gap, follow steps under Applying
Foam Tape to Overlay Frame. If there is little or no gap,
continue to Attaching the Overlay Frame.
10
CAUTION
Gasket
Door
Figure 16
Little or No Gap Objectional Gap
01/2007