TYAN Tiger MPX S2466 User Manual page 23

(Advanced Setup continued)
Base I/O
Interrupt
Parallel Port
Mode
Base I/O
Interrupt
DMA Channel
PCI Configuration
3.3 – Chipset Configuration
Options such as graphics and memory settings can be altered in this section.
Graphics Aperture
SERR Signal Condition
ECC Config
3F8, 2F8 These options are dependant on the IRQ
3E8, 2E8 settings below and vice versa. They set the I/O
address for the serial ports.
IRQ3 These options are dependant on the Base I/O
IRQ4 settings and vice versa. They set the IRQ for the
serial ports.
Enabled Toggles the Parallel Port. Use this port for
Disabled devices such as printers or Zip drives.
Auto
Output only Defines the mode that the Parallel port will
Bi-directional operate in. Leave on default setting for most
EPP compatibility.
ECP
378 These options appear when the Parallel Port is
278 enabled.
3BC
IRQ5 These options appear when the Parallel Port is
IRQ7 enabled.
Enabled Toggles the Parallel Port. Use this port for
Disabled devices such as printers or Zip drives.
Auto
Press [Enter]
32MB
64MB
128MB
256MB
512MB
1GB
None
None
Single bit
Multiple bits
Both
Disabled
EC (Single bit)
ECC (multiple bits)
ECC Scrub
23
http://www.tyan.com
Defines the size of system memory reserved
for AGP graphics data such as textures.
Usually, the higher the setting, the better
AGP performance, regardless of how much
actual RAM you have installed on your
motherboard.
Toggles the ERR signal in the listed
conditions. Leave at default setting.
Toggles memory correction.
EC – Error checking and status reporting
enabled. Data is not corrected.
ECC – EC but data is corrected.
ECC Scrub – ECC with memory contents
corrected after all reads with errors.