Error Messages; Using The Configuration Utility - TYAN Thunder HEsl S2567 User Manual

Error Messages

The following error messages may appear if something goes wrong during the boot process.
Error Message
Adapter removed from boot order, parame-
ters will be updated accordingly
Configuration data invalid, saving default
configuration!
Found SCSI Controller not in following
Boot Order List, to Add: Press Ctrl-C to
start Symbios Configuration Utility...
The SCSI BIOS Configuration Utility is a powerful tool. If you somehow disable all of
NOTE: your controllers, pressing CTRL-A (or CTRL-E on BIOS version 4.04 or later) after
memory initialization during reboot allows you to re-enable and reconfigure.*
Not all devices detected by the Configuration Utility can be controlled by the BIOS.
Devices such as tape drives and scanners require that a device driver specific to that
NOTE:
peripheral be loaded. The SCSI BIOS Configuration Utility does allow parameters to
be modified for these devices.

Using the Configuration Utility

Throughout the setup, selections that are not selectable are greyed out. Listed below are keys that you
can use throughout the setup.
Key
F1
F2
Arrow Keys
Home/End
+/-
Enter
ESC
* under qualification at time of print, check Tyan website for updates: http://www.tyan.com
Thunder HEsl S2567
Possible Reason For Error
This appears when an adapter is removed from the
system or relocated behind a PCI bridge.
This appears if none of the information in the
NVRAM is valid.
This appears when less than four adapters are in the
boot order and more adapters exist than are shown.
Function
Accesses the context sensitive help for the cursor-
resident field.
Sets cursor content to the menu selection area.
Select a menu item and press [ENTER].
Select item
Select item; use Up/Down/Left/Right keys to position
the cursor.
Changes item value to next relative value.
Press [ENTER] to execute the field's associated
function.
Abort/exit the current operating and/or exits the cur-
rent screen. User confirmation may occur.
45