Installing Add-On Cards - TYAN Thunder HEsl S2567 User Manual

2.11 Installing Add-on Cards**

There are a few rules you need to follow when installing add-on cards. In order to assure proper operation
and a quick installation, adhere to the following guidelines:
If you are going to install a PCI-bus interface card on your system, be aware that any one of the
six PCI slots can support a Master or Slave device.
NEVER force a card into a slot. If it doesn't fit, look at the socket on the motherboard to make
sure there are no wires or other obstructions to the slot.
NEVER plug an ISA card into a PCI slot, or vice versa. You will void your warranty and damage
your system board if you do this.
When plugging the card in, especially when installing long cards, try to push the entire card in at
one time. Don't force one end of the card into the socket first and then the other, or a rocking
motion between the card and the slot might occur, and could damage the pins within the socket.
Make sure the cards are seated securely into their slots.
Before turning on the system, make sure no cards are touching.
When installing the add-on cards**, make sure the cards are installed with even force; do not insert one
end and then the other. See the before (Figure 2.5a) and after (Figure 2.5b) example installation images
below for details.
1
2
* diagrams are provided as an example for installation, and may not represent an actual slot
** if 100MHz FSB CPU and/or 33MHz PCI card is used, the PCI bus will not run at 66MHz
22
Check orientation of card when installing
Figure 2.5a*
Push card down with even force
Figure 2.5b*
http://www.tyan.com