Storing Voice Tags; Navigation Help; Display Commands; Radio Commands - Cadillac DTS Navigation Manual

Navigation go to [destination]
(voice tag), navigation select
[destination] (voice tag): These
commands instruct the system to
select a destination saved under the
voice tag you have stored.
When a destination is requested
using a voice tag, the system will
state, Press or say cancel if not
correct . To cancel this voice tag
destination, using voice recognition,
push and hold the SRCE button on
the steering wheel until you hear a
beep, then say cancel . Canceling
voice tag destination by voice
recognition, must be done within
five seconds after the voice prompt.
If you are not currently driving on a
route, the system will automatically
create the voice tag destination as
the final destination. If you are
currently driving on a route, the
system will automatically create the
voice tag destination as a waypoint.
Up to three waypoints can be
created.

Storing Voice Tags

From the address book entry
information page, press the Add
Voice tag screen button. The
system will respond Name
Please? .

Navigation Help

Navigation Help: This command
instructs the system to assist with
navigation commands.

Display Commands

Use the following display commands
to set the display mode.
Display [set] day [mode]: Use this
command to set the display to
daytime mode.
Display [set] night [mode]: Use
this command to set the display to
night mode.
Display [set] auto [mode]: Use
this command to set the display to
automatic mode. The system will
change between day and night
mode automatically.
Infotainment System
System help: This command
instructs the system to assist with
display commands.

Radio Commands

The following are radio commands
you can access by clearly stating
the commands exactly as they are
written. The commands are only
available when you are in one of the
following audio modes, AM, FM,
or XM (if equipped).
Radio: This command instructs the
system to turn the audio system on.
Radio [band] [select] AM, radio
[band] [select] FM, radio [band]
[select] XM, radio [band] [select]
satellite: These commands instruct
the system to go to either the AM,
FM, or XM (if equipped).
Radio [select] (frequency) AM,
radio [select] (frequency) FM:
These commands instruct the
system to go to a specific frequency
on either AM or FM.
65