Clock; To Set The Time And Date; Power Outlets - Buick Encore Owner's Manual

5-6 Instruments and Controls
magnetically clean and safe
location, such as an open parking
lot, where driving the vehicle in
circles is not a danger. It is
suggested to calibrate away from
tall buildings, utility wires, manhole
covers, or other industrial structures,
if possible.
If code 125 is displayed on the DIC,
the compass needs to be
recalibrated.
Use the DIC buttons to begin
recalibrating the compass:
1. While the vehicle is in P (Park),
press the MENU button to
display the DIC menu.
2. Press and hold SET/CLR while
the Set Cal display is active.
3. Drive the vehicle in tight circles.
The display will begin to flash.
Continue driving in circles for
about 30 seconds. The compass
direction will be displayed.

Clock

The infotainment system controls
are used to access the time and
date settings through the menu
system. See
for information about how to use the
menu system.
Setting the Clock

To set the time and date:

1. Press the CONFIG button and
then turn the TUNE/MENU knob
to select Time and Date Settings
or press .
2. Select the desired feature.
3. Turn the TUNE/MENU knob to
adjust the highlighted number.
4. Press the TUNE/MENU knob to
select the next number.
5. To save and return to the Time
and Date Settings menu, press
BACK at any time or press the
TUNE/MENU knob after
adjusting the value.
6. Repeat steps 2 5 for the
remaining feature.
Setting the 12/24 Hour Format
1. Press the CONFIG button and
select Time and Date Settings or
press .
2. Select Set Time Format.
3. Turn the TUNE/MENU knob to
highlight the 12 hour or 24 hour
display format.
4. Press the TUNE/MENU knob to
select display format.

Power Outlets

The accessory power outlets can be
used to plug in electrical equipment,
such as a cell phone or MP3 player.
There is one accessory power outlet
on the center stack below the
climate control. This outlet is
powered when the key is in ON/
RUN or ACC/ACCESSORY, or until
the driver door is opened within