Adjusting The Display Backlight; Setting And Activating Alarm 1 - Brookstone IDESIGN User Manual

aDjUsTInG The DIsPlaY bacKlIGhT

There are 5 backlight settings for the display: HigH, MeDiUM, LOW, DiM and OFF .
Press the snOOZe button for 3 seconds and continue holding to toggle through
each of the backlight settings . The backlight setting will change every 3 seconds
while the snOOZe button is being pressed and held .
if the backlight is set to OFF, you may press the snOOZe bar once to turn
the backlight to LOW for 5 seconds .
note: if the backlight is set to oFF when the alarm sounds or during
snooze, the backlight will automatically illuminate on low. Backlight
will remain on during snooze.

seTTInG anD acTIvaTInG alaRM 1

1 . Press and hold the ALARM 1 seT button for 2 seconds . The clock will
go into Alarm 1 set mode . Alarm 1 hour will flash .
2 . Use the VOLUMe/seT dial to choose the hour . Press the ALARM 1
seT button to save the hour . The minutes will flash .
3 . Use the VOLUMe/seT dial to choose the minutes . Press the ALARM 1
seT button to save the minutes . The Alarm 1 time is saved . The Wake-to
choice icon will flash .
4 . Use the VOLUMe/seT dial to select your wake-to choice from iPod,
Radio or Buzzer .
5 . Press the ALARM 1 seT button to save all settings . if the ALARM 1 seT button
is not pressed while the hours, minutes or wake-to choice is flashing, the alarm
information will be saved and the clock will display after 5 seconds .
11