Selecting A Waveband; Automatic Tuning; Manual Tuning; Selecting The Seek Tuning Sensitivity - Blaupunkt Boston RCC 45 Operating Instructions Manual

Selecting a waveband

With this car radio you can select between
the following wavebands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
• Select the desired waveband by pres-
sing the FM or M•L button.
T
To switch between MW and LW:
• Press M•L.

Automatic tuning

/
• Press / ; the car radio will automati-
cally search for the next station.
When keeping the or the
sed, seek tuning will speed up in upwards or
downwards direction.
Up
Down
Down in short intervals
Up in short intervals
20
Manual tuning << >>
• Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.
When holding the right or left part of the
rocker switch pressed down, the frequency
scan is speeded up.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If "lo" is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If "lo" does not light up, the radio will also pick
button depres-
up weaker, distant stations (high sensitivity).
To switch over,
• Press lo or dx.

Switching from stereo to mono

If reception is poor, you may get better sound
quality by switching to mono:
• Press the lo button for approximately
2 seconds until you hear a beep.
Each time the radio is switched on, stereo
playback is activated.
The unit will automatically switch to mono if
the received signal is not strong enough for
stereo playback.
Changing the memory bank (FM)
You can shift between the memory banks I, II
and T in order to store stations and recall
them later.
The currently selected memory bank is indi-
cated in the display.
• Press the FM button as many times
T
until the desired memory bank lights up
in the display.

Storing stations

You can store six FM stations on the preset
buttons 1 to 6 for each of the memory banks
I, II and T.
• Select the memory bank.
• Tune in a station with the rocker switch
(either automatically or manually).
• Press the desired preset button until
you hear a beep.
Now the station has been stored.
The activated preset button is indicated in the
display.
Notice:
Should you tune in a station which has alrea-
dy been stored before, the corresponding
preset button and the memory bank will briefly
flash in the display if you have selected
another memory bank.