Receiving Traffic Programme Stations With Rds-Eon; Traffic Announcement Priority On/Off; Warning Beep; Switching The Warning Beep Off - Blaupunkt Boston RCC 45 Operating Instructions Manual

Receiving traffic programme stations with RDS-EON

Many FM broadcasters offer traffic messa-
ges for their service area at regular intervals.
All traffic programme stations transmit a spe-
cial carrier signal alongside their program-
mes, which is decoded by your car radio. If
this signal is identified, "TP" will appear in the
display (Traffic Programme).
In addition to these, there are also stations
which do not actually transmit traffic pro-
grammes themselves, such as NDR3, but by
using RDS-EON they offer the possibility to
receive the traffic messages broadcast by
another traffic programme station in the same
radio network. If you listen to one of these
stations, "TP" will appear in the display provi-
ded the priority for traffic programme stations
has been activated, i.e. "TA" must be display-
ed.
If a traffic announcement is broadcast, the
radio will automatically switch to the linked
traffic programme station (in this case, NDR2)
for the duration of the message and return to
the original programme (NDR3) afterwards.
Traffic announcement priority
on/off
If the priority for traffic announcement pro-
grammes is activated, "TA" will light up in the
display.
To switch the priority on or off:
• Press the TA button.
22
When pressing TA while a message is being
broadcast, the priority will be cancelled only
for this announcement. The unit will then
switch back to the previous condition. The
priority for other traffic messages remains
active.

Warning beep

If you leave the reception area of the traffic
programme station currently tuned into, you
will hear a warning beep after approximately
30 seconds.
This alarm tone will also be released when
pressing a preset button which has no traffic
programme allocated to it.

Switching the warning beep off

a) Tune into another station offering traffic
information:
• Press the rocker switch or
• a preset button which has a traffic
programme station allocated to it.
Alternatively:
b) Switch off the priority for traffic an-
nouncements:
• Press TA.
"TA" will disappear from the display.

Automatic seek tuning start

(tape operation)
When leaving the reception area of the tuned
in traffic programme station while listening to
a tape, the system will automatically start
searching for a new TA programme.
If no such station is found within approxima-
tely 30 seconds, a warning beep will sound.
To switch the warning beep off, proceed as
described above.
Adjusting the volume for traffic
announcements and the warning
beep
This volume was preset at the factory.
You can alter the value using the DSC function
(see "DSC programming, TA VOL").