Please Do Not Return This Product To The Store - Bissell Pet Hair Eraser 10N6 SERIES User Manual

T
roubleshooting
Vacuum cleaner won't run (continued)
Possible causes
2. Damaged power cord
Vacuum cleaner and tools won't pick up dirt
Possible causes
1. Incorrect height adjustment
2. Hose not attached to suction opening
3. Twist 'n Snap hose not securely attached
4. Crack or hole in hose
5. Broken or worn drive belt
6. Rotating floor brush bristles worn
7. Rotating floor brush jammed
8. Clog in vacuum
9. Dirt container full
10. Dirt container not installed properly
11. Filters are dirty
12. TurboBrush is clogged or debris is wrapped
around the brush roll
Vacuum cleaner is difficult to push
Possible causes
1. Incorrect height setting
Visible dirt escaping from cleaner
Possible causes
1. Dirt container full
2. Filters missing or installed incorrectly
3. Dirt container installed incorrectly
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

w w w . b i s s e l l . c o m
Remedies
2. Unplug, check for damage, replace
Remedies
1. Adjust powerfoot to correct height
2. Firmly push hose wand into hose
3. Make sure Twist 'n Snap hose is snapped
4. Check hose and replace if needed
5. Replace drive belt, see pages 12-13
6. Replace brush
7. Remove brush and clean debris from
8. Clear clogs, see page 15
9. Empty dirt container
10. Position correctly and lock in place
11. Check pre-motor and post-motor filters
12. See page 14 for maintaining TurboBrush
Remedies
1. Adjust powerfoot to correct height setting
Remedies
1. Empty dirt container
2. Check pre-motor and post-motor filters for
3. Pull out and re-insert dirt container correctly
authorized service representative.
as necessary
wand base
into locked position
brush ends
correct installation
17