Maintenance And Care; Machine Storage - Bissell CLEANVIEW PROHEAT 53U6 SERIES User Manual

M
aintenance and care
Hard Floor Cleaning continued
8. While pressing the spray trigger, make
one slow forward wet pass and another
back.Caution: Do Not Overwet.
9. Repeat the motion without pressing the
spray trigger using the hard floor tool to
squeegee and suction up the dirty water.
10. When finished, remove hard floor tool,
rinse and let dry before storing. Refer
to the Maintenance and care section on
page 15 for machine clean up and
storage instructions.Machine care
For best results, a few simple steps can
assure your machine is well maintained
after cleaning is complete.
1. Turn power switch off. Unplug the
machine and wrap the power cord.
2 . After emptying the 2-in-1 water tank, rinse
it with running hand hot tap water, tak-
ing care to clean underneath and around
the heavy duty bladder. Clean out red lint
screen. Removable nozzle may be rinsed if
necessary. Refer to page 12.
3. Replace the 2-in-1 water tank on the
machine.
4. Any loose hair or debris can be pulled
from the brush roll and thrown away.
5. To clean attachments, remove from hose and
rinse in clean, running water. Dry before
storing. Clean the hose by suctioning clean
water from the tap. Before wrapping back
on machine, lift end of hose and stretch out
to ensure all water is cleared from hose.
Refer to page 13, illustrations 11 and 12.
6. Wipe the machine's exterior with a soft cloth.
7. After carpet is dry, vacuum again to
remove hair and fuzz.

Machine storage

Put the unit away in a closet or
basement for the next use. Store
cleaner in a protected, dry area. Since
this product uses water, it must not be
stored where there is a danger of
freezing. Freezing will damage internal
components and void the warranty.
w w w . b i s s e l l . c o m
15