Baumatic BDW15 Instruction Manual page 28

E4
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E5
o Switch cannot shut off automatically- program not finishing its
cycle.
Low voltage or power switch failure.
Call Baumatic Service Department.
E6
o Open circuit
Thermistor
Call Baumatic Service Department.
E7
o Short circuit
Thermistor
Call Baumatic Service Department.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Press and hold down the delay start button and the ON/OFF
button, until the appliance switches off.
o Wait for 5 seconds, and then switch back on the appliance using
the ON/OFF button.
o Wait for a further 5 seconds before attempting to set a wash
program, using the program selection button.
IMPORTANT: If any other fault code appears in the
display window, you should not attempt to clear it yourself
and contact the Baumatic Service Department.
28