HP Mini 5101 Maintenance And Service Manual page 72

Remove the fan and heat sink assembly:
1. Disconnect the fan cable from the system board.
2. Loosen the 4 Phillips PM2.0×7.0 captive screws (1) that secure the fan and heat sink assembly to
the system board.
NOTE:
3. Remove the 2 Phillips PM2.0×3.0 screws (2) that secure the fan and heat sink assembly to the
system board.
4. Remove the fan and heat sink assembly (3).
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the fan and heat sink
assembly and the system board each time the fan and heat sink assembly is removed. Thermal paste
is used on the processor (1) and (3), and thermal tape is used on the Northbridge chip (2) and (4).
Replacement thermal material is included with all fan and heat sink assembly, and system board spare
part kits.
64 Chapter 4 Removal and replacement procedures
The screws are numbered 1 through 4. Follow this order when removing the screws.