Table 3-5. Post Messages - HP OMNIBOOK 2100 Service Manual

Message
0200 Failure Fixed Disk
0210 Stuck key
0211 Keyboard error
0212 Keyboard Controller Failed
0213 Keyboard locked - Unlock key switch
0220 Monitor type does not match CMOS - Run SETUP
0230 Shadow Ram Failed at offset: nnnn
0231 System RAM Failed at offset: nnnn
0232 Extended RAM Failed at offset: nnnn
0250 System battery is dead - Replace and run SETUP
0251 System CMOS checksum bad - Default configuration used
0260 System timer error
0270 Real time clock error
0280 Previous boot incomplete - Default configuration used
0281 Memory Size found by POST differed from CMOS
02B0 Diskette drive A error
02B1 Diskette drive B error
02B2 Incorrect Drive A type - run SETUP
02B3 Incorrect Drive B type - run SETUP
02D0 System cache error - Cache disabled
02F0: CPU ID:
02F4: EISA CMOS not writeable
02F5: DMA Test Failed
02F6: Software NMI Failed
3-18 Troubleshooting and Diagnostics

Table 3-5. POST Messages

Description
Fixed disk is not working or not configured properly. Check to see if fixed disk is attached
properly. Run Setup. Find out if the fixed-disk type is correctly identified.
Stuck key on keyboard.
Keyboard not working.
Keyboard controller failed test. May require replacing keyboard controller.
Unlock the system to proceed.
Monitor type not correctly identified in Setup
Shadow RAM failed at offset nnnn of the 64k block at which the error was detected.
System RAM failed at offset nnnn of in the 64k block at which the error was detected.
Extended memory not working or not configured properly at offset nnnn.
The CMOS clock battery indicator shows the battery is dead. Connect the ac adapter for at
least 24 hours, replace the motherboard.
System CMOS has been corrupted or modified incorrectly, perhaps by an application
program that changes data stored in CMOS. The BIOS installed Default Setup Values. If you
do not want these values, enter Setup and enter your own values. If the error persists, check
the system battery. Connect the ac adapter for at least 24 hours, replace the motherboard.
The timer test failed. Requires repair of system board.
Real-time clock fails BIOS test. May require board repair.
Previous POST did not complete successfully. POST loads default values and offers to run
Setup. If the failure was caused by incorrect values and they are not corrected, the next boot
will likely fail. This error is cleared the next time the system is booted.
Memory size found by POST differed from CMOS.
Drive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the drive is
defined with the proper diskette type in Setup and that the diskette drive is attached correctly.
Type of floppy drive A: not correctly identified in Setup.
Type of floppy drive B: not correctly identified in Setup.
RAM cache failed and BIOS disabled the cache. On older boards, check the cache jumpers.
You may have to replace the cache. See your dealer. A disabled cache slows system
performance considerably.
CPU socket number for Multi-Processor error.
ServerBIOS2 test error: Cannot write to EISA CMOS.
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
HP OmniBook 2100/3000/3100