Figure 2-5. Removing The Ram Cover; Figure 2-6. Removing A Ram Board - HP OMNIBOOK 2100 Service Manual

Hide thumbs Also See for OMNIBOOK 2100:

Reference manual (150 pages)

User manual (53 pages)

Service manual (20 pages)

Table Of Contents

100

101

102

103

104

105

106

107

Table of Contents

Removal Procedure

1. Unplug the ac adapter, if present, and remove the battery.

2. Remove the hard disk drive (see page 2-5).

3. Slide open the RAM cover about 3 mm, then lift off the cover.

Note

For an OmniBook 3000, if the RAM cover does not have a Mylar insulator on the inside, replace

the cover with a new one. (Service note 3000-07.)

4. Release the two metal latches at the sides of the RAM board, so the free edge of the board pops

up.

5. Pull the board out of the connector.

Note:

Some OmniBook 2100/3100s

have only one RAM slot.

For an OmniBook

2100/3100 with a

Pentium processor,

no more than 32 MB

is supported in this

slot.

Reassembly Notes

Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press

down at both sides until both latches snap closed.

Place the RAM cover about 3 mm from its closed position, then slide it closed.

2-8

Removal and Replacement