Upper Threading; Lower Thread; Upper Thread; Needle - Baby Lock Urity BLTY Instruction And Reference Manual

PREPARING FOR BOBBIN WORK

■ Lower thread

We recommend the following types of threads for
bobbin work.
No.5 or finer hand embroidery
thread or decorative thread
Flexible woven ribbon
Fine embroidery ribbon (silk or
silk-like material) (3.5 mm (approx.
1/8 inch) or less is recommended)
* When wide ribbon or heavy weight threads are being used, we
recommend test sewing with the thread through and also
bypassing the bobbin case tension to see which gives the best
stitching results.
If wide ribbon such as 3.5mm (approx. 1/8 inch) is to be used,
we recommend that bobbin case tension not be applied. Refer
to page S-110 for more detailed instructions.
Note
• Do not use thread heavier than No.5 hand
embroidery thread.
• Some threads may not be appropriate for
bobbin work. Be sure to sew trial stitches
before sewing on your project.

■ Upper thread

Sewing machine embroidery thread (polyester
thread) or monofilament (transparent nylon) thread.
If you do not wish for the upper thread to be visible,
we recommend using transparent nylon
monofilament thread or polyester light weight
thread (50wt. or above) that is the same color as the
lower thread.

■ Needle

Use a needle appropriate for the upper thread and
fabric being used. Refer to "Fabric/Thread/Needle
Combinations" of "Basic operations".
S-106

■ Presser foot

Utility stitches or decorative stitches:
Monogramming foot "N"
Free motion sewing:
Free motion open toe quilting foot "O"

■ Fabric

Be sure to sew trial stitches on a piece of scrap
fabric, which includes the same threads and fabric
as what is being used in your project.
Note
• The sewing results may be affected by the
type of fabric used. Before sewing your
project, be sure to sew trial stitches on a
piece of scrap fabric that is the same as the
fabric used in the project.

Upper Threading

a
Install a needle appropriate for the upper
thread and fabric to be used.
For details on installing the needle, refer to
"CHANGING THE NEEDLE" of "Basic operations".
b
Attach the presser foot.
c
Thread the machine with the upper thread.
For details on threading the machine, refer to
"Upper Threading" of "Basic operations".