Baby Lock Ellure PLUS BLR3 Instruction And Reference Manual page 190

²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²²
APPENDIX
Error Message Probable Cause
The buttonhole, bar tack or darning stitch was selected and the "Start/
Stop" button was pressed while the buttonhole lever is raised.
The "Start/Stop" button, "Reverse/Reinforcement Stitch" button or
"Thread Cutter" button was pressed while the presser foot was raised.
You tried to combine more than 70 decorative stitches, satin stitches,
cross stitches or combined utility stitches.
The memory is full and the stitch or pattern cannot be saved.
You pressed the back key or the utility stitch key or the embroidery key
while a pattern was selected.
You changed the stitch pattern settings, and then tried to save them by
pressing the manual memory key.
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
This message is displayed when the embroidery unit is trying to
initialize while the embroidery foot is lowered.
A pattern was being retrieved from a USB flash drive (USB flash
memory) containing more than 200 embroidery patterns.
In addition, this message will appear if embroidery patterns containing
many colors have been saved on the USB media, even if it contains
data for no more than 200 patterns.
Retrieving the pattern
The "Reverse/Reinforcement Stitch" button, "Needle Position" button
or "Thread Cutter" button was pressed while the bobbin winder shaft is
moved to the right.
A pattern is being saved.
The "Start/Stop" button or "Reverse/Reinforcement Stitch" button was
pressed when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
When the embroidery unit is attached.
188