Declaration Of Conformity; Whatʼs In The Box - Axminster SIEG C4 User Manual

Quantity Item
1 No. Mill with Chuck and Draw Bar fitted
Box containing:-
1 No. Chuck Key
1 No. Nipple ʻCʼ Spanner 28mm-32mm
4 No. ʻTʼ Slot Keepers
1 No. Tommy Bar
1 No. Oiling Bottle
1 No. Spare Fuse (250v x 1 Amp)
1 No. Guarantee Card
!
Please read the Instruction Manual prior to using your new machine; as well
as the installation procedure, there are daily and periodic maintenance
recommendations to help you keep your machine on top line and prolong its life.
Keep this Instruction Manual readily accessible for any others who may also be
required to use the machine.
Having unpacked you machine and its accessories, please check the contents against
the equipment list "Whatʼs in the box", if there are any discrepancies, please contact
Axminster Power Tool Centre using the procedures laid down in the catalogue. Please
dispose of the packaging responsibly, much of the material is bio-degradable. The
machine and its accessories will arrive coated with heavy corrosion preventative grease.
This will need to be cleaned from the machine, its components and accessories prior to
it being set up and commissioned. Use coal oil, paraffin or a proprietary degreaser to
remove the barrier grease. Be warned, it will stain if you splash it on clothing etc., wear
overalls, coverall et al., rubber gloves are also a good idea, as is eye protection if your
cleaning process tends to be a little bit enthusiastic. After cleaning, lightly coat the
exposed metal surfaces of the machine with a thin layer of light machine oil. N.B If you
used paraffin/kerosene make sure you apply this thin film sooner rather than later.
The undersigned, Ole Stilling authorised
by Shanghai SIEG Machinery Co., Ltd.
No.555 Caofeng Rd., South to No. 17 Bridge of
Caoan Rd., Shanghai
declares that this product:
(Micro Mill)
X1
manufactured by Shanghai SIEG Machinery Co.
is in compliance with the following standards or
standardisation documents in accordance with
Council Directives
EN55014-1:2000, EN55014-2:1997
EN61000-3-2:2000, EN61000-3-3:1995
(89/336/EEC amended by 93/68/EEC
21

DECLARATION OF CONFORMITY

)
WHATʼS IN THE BOX
Model Number
X1