Storage - Axis P3384–VE User Manual

AXIS P3384–VE Network Camera
System Options
UPnP TM
The Axis product includes support for UPnP
systems and clients that support this protocol.
can be disabled under System Options > Network > UPnP
UPnP TM
RTP/H.264
The RTP port range and multicast settings are configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.

Storage

SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.
The Axis product supports SD cards with the following file systems:
ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To access
•
data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.
vFAT — most SD cards are pre-formatted with vFAT when purchased.
•
If required, the SD card can be re-formatted to the desired file system. To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage and click SD Card.
3. Click Format and select the desired file system.
Note
During formatting any previous data stored on the disk will be lost.
Mounting is done automatically when the card is inserted or when the product is started. A manual mount is only required if the
card has been unmounted and not ejected and re-inserted.
To unmount the SD card:
1. Go to System Options > Storage and click SD Card.
2. Click Unmount.
3. The card can now be removed.
The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.
TM . UPnP TM is enabled by default and the product is automatically detected by operating
TM .
46