Friedrich Twintemp EL36 Installation And Operation Manual page 13

Standard chassis models
Hide thumbs Also See for Twintemp EL36:
Table of Contents

Advertisement

Available languages

Available languages

STEP 11
INSTALL THE SIDE WINGBOARD PANELS – Be sure the
cabinet has been secured to the win dow sill and that the out-
side support brackets have been installed as shown in Figure
D. Raise the window sash and install the right and left side
wingboard panels. (See Figure G).
STEP 12
INSTALL THE WINDOW SEALING GASKETS – Measure
and cut the vinyl window seal gasket (grey color, Item # 12) to
fi t the width of the window, and install as shown in Figure H.
Pull the window sash down behind the gasket. Measure and
cut the dark foam window seal gasket (Item #13) and install it
between the upper glass panel and the top part of the lower
sash. (See Figure H).
NOTE: FOR REASONS OF SECURITY AND SAFETY, THE
CUSTOMER MUST PRO VIDE A MEANS OF PRE VENT ING
THE WINDOW FROM OPENING.
Figure G
SECURE THE SIDE WINGBOARD PANELS TO
THE SIDE ANGLES WITH FOUR (4) #8 x ½" LONG
SCREWS (ITEM #11), TWO ON EACH SIDE.
TOP OF CABINET
PLACE WINGBOARD PANEL IN
WINDOW JAM TO COMPRESS THE
SPRINGS INSIDE THE RUNNERS,
AND SWING THE PANEL INTO PLACE
INDICATED BY THE DOTTED LINE.
SECTION A - A
920-198-00
WINDOW JAM
STEP 13
When possible, caulk the outside of the installation with
industrial type caulking to prevent weath er leaks.
STEP 14
INSTALL CHASSIS – After installing the shell, slide the chassis
into the shell stopping approximately 3" from full insertion. Stuff
the chassis seal gasket one inch deep between the chassis
and the shell (see Figure I). Begin at either bottom corner and
go up the side, across the top, and down the opposite side. Then
push the chassis all the way into the shell for the remaining distance
so that the plastic front meets the front edge of the shell.
If chassis seal gasket is not installed, the operation of the unit
will be negatively affected. Operational noise and outside
noise will also be amplifi ed.
STEP 15
Reattach the chassis retainer wire with the same screw as in
Step 3 (See Figure A).
Figure H
INSERT VINYL WINDOW SEAL
GASKET OVER TOP ANGLE
TO WINGBOARD (ITEM #12)
VINYL
WINDOW
GASKET
SECTION B - B
INSERT FOAM WINDOW
SEAL GASKET (ITEM # 13)
LOWER WINDOW SASH
TOP WINGBOARD ANGLE
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Twintemp em18Twintemp es16Twintemp em24Twintemp es12Quietmaster sm18Quietmaster sm24 ... Show all

Table of Contents