Openvms Utility Components - HP Smart Array 5300A User Manual

OpenVMS Utility Components

General Note
New releases of the HP Insight Management Agents for OpenVMS and Array
Configuration Utility XE are available which address prior incompatibilities
between certain versions of the OpenVMS Management Agent kit and the Smart
Array Configuration Utility. Version compatibility is detailed in the table below:
Table 1: OpenVMS Insight Management Agents Kit - ACUXE Kit
Compatibility
OpenVMS Management Agent Kit
Version and Package Name
Version 3.02, PCSI kit name:
HP-AXPVMS-V73_MGMTAGENTS_V0300-36-1.PCSI
V3.0 and V3.01
Version 2.4, PCSI kit name:
CPQ-AXPVMS-V73_MGMTAGENTS_V0204-11-1.PCSI
HP Insight Management Agents for OpenVMS
•
The new v3.02 release of the HP Insight Management Agents for OpenVMS
provides full Smart Array utility support for the KZPDC controller under
OpenVMS versions 7.3-1 and 7.3-2. This kit must be used in conjunction with
Smart Array Configuration Utility kit version B0126 or later. Kit version
B0105 of the ACU-XE utility is not supported with OpenVMS Management
Agent kit version 3.00 or higher.
•
The v3.02 kit can be obtained from the HP Insight Management Agents for
OpenVMS home page located at:
http://h71000.www7.hp.com/openvms/products/mgmt_agents/
•
The HP Management Agents for OpenVMS kit version v3.02 supersedes the
kit found in the software media kit supplied with the KZPDC controller.
•
Users are strongly advised to review the instructions in the v3.02 kit
Installation Guide before attempting to update system/cluster environments
6 Release Notes – Smart Array 5300A Backplane RAID Controllers
Smart Array Configuration Utility Kit
Version and Package Name
Version B0126, PCSI kit name:
HP-AXPVMS-ACUXE-B0126--1.PCSI
No support
Version B0105, PCSI kit name:
COMPAQ-AXPVMS-ACUXE-B0105--1.PCSI