Front Side Panel - AMC WiFi Wireless Transmitter TR1a Instructions For Installation And Operation Manual

FRONT SIDE PANEL

1. Connector for IR Blaster
The 3.5mm mini connector is for IR
B l a s t e r O u t p u t . I R B l a s t e r s c a n b e
hooked up to the connector.
2. Connector for Stereo Audio Pre-Out
(Option)
The 3.5mm mini connector is for Stereo
A u d i o P r e - O u t . T h e P r e - O u t i s f o r
FRONT PANEL
1. LED 1 (Orange) Wireless LED
Blinking slowly : wireless is connecting
Blinking quickly : wireless is connected
and transmitting data.
2. LED 2 (Green) Power LED
This is a Power On LED.
3. LED 3 (Red) Tuner Status
Tuner Initialization Confirmed
4. RESET
This is a switch to reset TR1a. When
TR1a experiences unstable operation or
trouble for connecting,
connecting to external Stereo Audio
systems and the latency between the
P r e - O u t a n d Vi d e o w i l l h a v e t o b e
adjusted by time delay module. So, the
Pre-Out is an option and will be installed
f o r s p e c i a l d e s i g n e d p r o j e c t s a n d
according to special orders only.
you can use the switch to reset TR1a by
following procedure,
a. Switch off the TR1a
b. Press and hold the reset button and
then switch on TR1a
c. Wait for 5 seconds and then release
the reset button.
d. the TR1a should have then been reset
to factory default setup.
6