Configuring Ip Settings In Centreware Internet Services - Xerox Phaser 7800 System Administrator Manual

Network Configuration
Configuring Dynamic Address Settings for IPv4
1. At the control panel, touch Printer.
2. Touch the Tools tab, then touch Setup.
Touch Network & USB.
3.
4. Touch Ethernet.
5. Touch TCP/IP (v4).
6. Touch On:DHCP.
7. Touch OK.
Configuring Dynamic Address Settings for IPv6
At the control panel, touch Printer.
1.
2. Touch the Tools tab, then touch Setup.
3. Touch Network & USB.
4. Touch Ethernet.
5. Touch TCP/IP (v6).
Touch DHCPv6.
6.
7. Select Enable DHCPv6.
Under Mode, select Router, Stateful, or Stateless.
8.
Touch Apply Now.
9.
10. Touch OK.

Configuring IP Settings in CentreWare Internet Services

If your printer has a valid network address, you can configure TCP/IP settings in CentreWare
Internet Services.
Configuring IPv4
You can use IPv4 or IPv6 in addition to or in place of the other.
In CentreWare Internet Services, click Properties > Connectivity > Protocols.
1.
2. Click IP (Internet Protocol) > IPv4.
Under Protocol, select Enabled to enable the protocol.
3.
CAUTION: If both IPv4 and IPv6 are disabled, you cannot access CentreWare Internet Services. To
access IPv4 and IPv6 settings in CentreWare Internet Services, enable TCP/IP at the printer control
panel. If you disable TCP/IP or change the IP address, any dependent protocols are disabled and the
network controller restarts.
22 Phaser 7800 Color Printer
System Administrator Guide